InPhasmophobia, the D.O.T.S. projector is an extremely useful piece of equipment. In fact, you’ll oftentimes have to use the D.O.T.S. Projector to rule out or confirm a ghost when on a contract. However, the tool can be a bit tricky to use if you’ve never done so far. Here’s how to use the D.O.T.S. projector inPhasmophobiaand get the most out of it.
How to properly setup the D.O.T.S. projector
to use the D.O.T.S. projector inPhasmophobiato properly identify evidence via tracking a ghost’s movement, you need to set up the projector on the wall or floor. In this regard, it’s a bit like the motion sensor. Once you have the D.O.T.S. Projector in your hands, use the ‘F’ key to place down the projector. You can then use the scroll wheel to rotate the projector around to get it the best angle.
The D.O.T.S. projector emits a cone of green lasers from the projector itself in the direction it is facing. If you are using the Tier 1 D.O.T.S. projector which all players begin with, I recommend right-clicking. This will enable a cone of the beams as opposed to just focusing on one singular location.
Once you have a good location picked out as to where you think the ghost may be, aim the D.O.T.S. projector so that the beams are shining where you think a ghost will walk. If a ghost walks through the dots, you will be able to see a translucent entity as it walks through the grid of laser dots. It can be tricky to see, however, and most players have luck by setting down a video camera with Night Vision enabled aimed at the dots and then checking the cameras on the van. Also, the Goryo cannot be seen on the D.O.T.S. projector without using the Night Vision-enabled video camera.
Which D.O.T.S. projector is best inPhasmophobia?
As you might have guessed, the Tier 3 D.O.T.S. Projector is without a doubt the best one to use inPhasmophobia. It has the biggest range, the widest spotlight, and even has automated scanning. Here are all of the tiers of D.O.T.S. projectors inPhasmopbia:
